ATS Panels
Automatic Transfer Switch panels that switch power sources instantly, keeping critical loads online during outages.
When mains power fails, an ATS panel is what decides how fast — and how smoothly — your site switches to generator power. Our ATS panels detect the outage, initiate generator start and transfer the load automatically, then reverse the process the moment mains power is restored, all without manual intervention. Panels are sized to the actual connected load rather than a standard catalogue size, so switching is clean even on sites with large motor loads or sensitive equipment.
- Automatic changeover between mains and generator
- Sized from small commercial to large industrial loads
- Manual override and full status indication
- Factory tested before installation
One ATS Line, Every Load Size
From small commercial premises to large industrial facilities, our ATS panels are sized and configured around the connected load — so the transfer is clean, not just automatic.
How We Build ATS Panels That Switch Cleanly
An automatic transfer switch only earns its name if the transfer is actually seamless. Our ATS panels are sized to the real load, tested under real switching conditions, and built with a manual override for the times you need to take control yourself.
Panels Built Around Your Actual Connected Load
Rather than fitting a standard size, we size every ATS panel to your site's real load profile, so switching stays clean even with large motor starts or sensitive electronic equipment on the circuit.
Fast, Reliable Transfer On Mains Failure
The panel detects loss of mains, signals the generator to start and transfers the load automatically within seconds, then transfers back once utility power has stabilised.
Manual Override On Every Panel
Every ATS panel includes a manual override, so your team can force a transfer or hold a source manually during testing, maintenance or an unusual site situation.
Load-Tested Before It Leaves The Workshop
Each panel is tested through full transfer cycles under load before dispatch, confirming switching times and contactor operation match specification before installation.