Generator Control Panels
Purpose-built generator control panels for monitoring, protection and automatic control of standby and prime power sets.
A generator is only as reliable as the panel controlling it. Our control panels handle auto mains failure switching, engine start/stop sequencing, protection trips and real-time monitoring, so your standby set responds correctly the moment mains power fails — without an operator needing to intervene. Each panel is configured and tested against the exact generator model it will control before it ever reaches site, so the controller, the alternator and the engine are all speaking the same language from day one.
- Auto mains failure (AMF) control logic
- Real-time monitoring of voltage, load and faults
- Remote start/stop and alarm integration
- Built and tested to match your generator model
One Control Platform, Every Generator Size
From single small standby sets to multi-generator sites running in parallel, our control panels are configured to match the generator, the load and the site — not fitted after the fact.
How We Build Control Panels That Respond Correctly
A control panel that hesitates during a power failure defeats the purpose of having a generator at all. Our approach is to configure, test and document every panel against the specific set it will control, before it ever reaches your site.
Configured To Your Exact Generator Model
Each control panel is programmed against the make, model and control system of the generator it will run, so start sequencing, protection thresholds and alarms are correct from the first power failure.
Auto Mains Failure Switching Built In
On loss of mains power, the panel starts the set, transfers the load and monitors performance automatically, restoring mains and shutting the generator down once utility power is stable again.
Real-Time Status On Voltage, Load And Faults
Operators can see voltage, frequency, load and fault status directly on the panel, with remote monitoring and alarm integration available for unmanned or multi-site operations.
Commissioned Against The Actual Generator Set
Before handover, every panel is tested on the real generator it will control — not a bench simulation — confirming start, transfer and shutdown sequences all behave as designed.